中文

EMI Coils

STIB4 Series

STIB4 Series is a common mode EMI data line filter, a ferrite core wound by copper wire and fixed on a dip type bobbin. It’s often used for signal filter to suppress noise because it’s high impedance and large rated current.

TIB4 Series is a common mode EMI data line filter, a ferrite core wound by copper wire and fixed on a dip type bobbin. It’s often used for signal filter to suppress noise at communication equipments because it’s high impedance.

TIB2 Series is a differential mode EMI data line filter, a ferrite core wound by copper wire and fixed on a dip type bobbin. It’s often used for signal filter to suppress noise at communication equipments because it’s high impedance.

WRH Series is a economical differential mode EMI data line filter. It consists of a copper wire through one or two pieces ferrite beads and can be used in automated insertion line. It’s often used for power circuit to prevent high frequency noise or withstand high peak current, ex : power supplier, resonant circuit, SCR switch circuit, Class-C power amplifier.

S5H Series is a SMD type bead, a ferrite core with 2.5ts copper wire winding directly. It’s often used for signal filter or DC line filter to suppress outside noise at communication equipments because it’s high impedance and large rated current.

R6H Series is a ferrite core with 2.0 / 2.5 / 3.0 turns copper wire winding directly. It’s often used for signal filter or DC line filter to suppress outside noise at communication equipments because it’s high impedance and large rated current.

SUSB1206 Series is a SMD type common mode EMI data line filter, a ferrite core wired with copper wire directly and assemble with another flake ferrite to become a close loop filter. Due to it's good noise suppression performance in high frequency, it's often used for USB 2.0, IEEE1394 , LVDS (Low-voltage differential signaling) and suppress radiation noise in signal cables.

SUSB0805 Series is a SMD type common mode EMI data line filter, a ferrite core wired with copper wire directly and assemble with another flake ferrite to become a close loop filter. Due to it's good noise suppression performance in high frequency, it's often used for USB 2.0, IEEE1394 , LVDS (Low-voltage differential signaling) and suppress radiation noise in signal cables.

Other Coils

RFID series

The LF RFID Transponder SMD Coil is a SMD type antenna used in a parallel LC circuit for 125 kHz RFID system. By tuning the L(inductance) and C(capacitor) to resonate in the LC circuit of a reader or tag, can get a better read distance and sensitivity.